Altronix ACM8E Installation Instructions Uživatelský manuál stáhnout pdf (Strana 5)

LED Diagnostics:

ACM8 & ACM8CB Access Power Controller

ED ON OFF

LED 1- LED 8 (Red) Output relay(s) energized. Output relay(s) de-energized.

Trg (Green) FACP input triggered (alarm condition). FACP normal (non-alarm condition).

Terminal Identification Tables:

ACM8 & ACM8CB Access Power Controller

Terminal Function/Description

Legend

- Power + 12VDC or 24VDC input from power supply board.

- Control + These terminals can be connected to a separate, UL listed power supply to

provide isolated operating power for the ACM8/ACM8E/ACM8CB/ACM8CBE

(jumpers J1and J2 Must be removed).

TRIGGER From normally open and/or open collector sink trigger inputs

INPUT 1- INPUT 8 (request to exit buttons, exit pir’s, etc.).

IN, GND

OUTPUT 1-OUTPUT 8 12 to 24 volts AC/DC trigger controlled outputs:

NC, C, NO, COM

Fail-Safe [NC positive (+) & COM Negative (-)],

Fail-Secure [NO positive (+) & COM Negative (-)],

Auxiliary output [C positive (+) & COM Negative (-)]

(When using AC po

wer supplies polarity need not be observed),

NC, C, NO become form “C” 5 amp 24VAC/VDC rated dry outputs when fuses are

removed (ACM8/ACM8E). Contacts shown in a non-triggered state.

FACP INTERFACE Fire Alarm Interface trigger input from FACP. Trigger inputs can be normally open,

T, + INPUT - normally closed from an FACP output circuit

ig. 3 through 7, pg. 6)

FACP INTERFACE Form “C” relay contact rated @ 1 amp 28VDC for alarm reporting.

NC, C, NO (This output has not been evaluated by UL).

- 5 -

1 2 3 4 5 6 7 8

Žádné komentáře

Altronix ACM8E Installation Instructions Uživatelský manuál Strana 5